Using IDE Cable Select
IDENTIFICACION DE ALMACENAMIENTO SECUNDARIO – COMPETENCIAS INFORMATICAS
All about Linux: Adding a Second Hard Disk in Linux
Amazon.com: StarTech.com 18in Dual Drive Ultra ATA IDE Hard Drive Cable - IDE / EIDE cable - UDMA 66/100 - 40 pin IDC (F) to 40 pin IDC (F) - 1.6 ft - IDE66, Gray : Electronics
Hard Drive Configuration
Troubleshooting ATA/IDE Hard Disks | Troubleshooting Storage Devices | InformIT
Mikes Hardware | How To | Connecting IDE Hard Drives
AT-IDE-EIDE (3.5 and 5.25-Inch) HDD Jumper Setting
MSI SYSTEM / MASTER / SLAVE IDE HDD Cable Connector 18" Red | eBay
PATA | Upgrading and Repairing PCs: The ATA/IDE Interface | InformIT
Which jumper setting do I use when cloning my original Western Digital Protege drive (master drive)? Its currently set to the cable select setting from the factory. : r/originalxbox
Dispositivos IDE. Master, Slave y Cable Select. - Jota informatica
DiamondMax Plus 8 Ultra DMA 133 - Jumper, CHS, and Install Guide | Support Seagate US
IDE drive Jumper
jumper settings hard drive | DATA RECOVERY UNION
HDD Master | TechPowerUp Forums
PC Hell: Master/Slave Settings vs. Cable Select when Connecting IDE Hard Drives
Dispositivos IDE. Master, Slave y Cable Select. - Jota informatica
Dispositivos IDE. Master, Slave y Cable Select. - Jota informatica
elhacker.NET on Twitter: "Cuando no existían las conexiones SATA los discos duros y unidades ópticas se configuraban como primario (master) o secundario (slave) y se conectaban a la placa base al bus
EMTT: Jumpers en discos duros ATA y SATA
